Things You Should Know About Rosin Press Extraction Process
The extraction of rosin is an innovation that has been discovered lately. When extracting rosin there are very many considerations that should be made. The procedures are normally affected by certain factors. You must check these elements to ensure that they do not exceed their limits during extraction. The most crucial thing is to understand the effect each element has on the rosin. The process of extracting rosin is carried out through two methods. They all involve press process. A person can either prefer the cold press if not heat press.When you choice one of the two options you will still get rosin. Little heat is necessary in cold extraction. Seeds are ground to create what is known as a paste. Pressure is used when oil is being separated from the paste.
A number of people think that pressure is the only force used in the cold extraction. You will also need to apply heat. The heat you will need is at the lowest level. Extracting rosin without heat will be hard if not impossible. When oil is being extracted from the paste there is a screw that presses the paste hard to pass oil through the filter. In cold press, the amount of oil produced is not much while the quality is the best.
The regulation of this procedure will differ from one country to another. Any person who intends to produce rosin need to read these laws and operate within their limits. In most occasion the most important regulation to follow would be being certified. It will be an offence to continue obtaining rosin if you have not gotten the certification. The authorities will tell you the best or the required temperatures for extraction. The temperatures that exceed the requirement can get you into trouble.
If you are living in Europe you must follow these laws because they are very clear on the subject.In the US such laws are not applicable. In this case you will be responsible for every step and decision that you make in the process. If you settle on the heat press, you should know that a source of heat must be available.Hot water will be added to the paste to produce heat in the mixture. Direct heating is also an option in this case. Some people will use gas while others will use electric heaters. The good thing about using heat is that you will produce a lot of rosin. If you give emphasis to quality than the quantity this might not be the way for you. After heating the final product might not retain the original color. The rosin you acquire after extraction will have no chemicals added to them and all other substances are filtered by the filter bags.